Smart Formwork Axial Force Meter（VW）

The meter typically installs in line with the tie rod or spindle. You’ll need bearing plates on both sides to distribute the load. Kingmach supplies standard plates, but if your rod size is different, they can machine custom adapters. Tighten the assembly as you normally would, and the meter reads the force passing through.

The sensor outputs a frequency, so you need a device that can excite and measure a vibrating wire gauge. Kingmach offers handheld readouts, or you can connect to many brands of dataloggers. For continuous monitoring, the 4-pin connector plugs into a centralized logger with VW channels.

Yes, as long as it’s not overloaded beyond its safe limit. Remove it carefully after stripping the formwork, clean off concrete residue, and check the threads. The calibration should hold, but we recommend a spot-check with a known load if you’re pushing a tight schedule.

The meter has an internal thermistor, so you can measure temperature and correct the force reading manually or in software. The steel body and wire are designed to minimize thermal zero shift, but for precise measurements, temperature correction is a standard practice.

It depends on the modification. A non-standard full-scale range with the same mechanical dimensions usually takes about two to three weeks because it’s a different sensing element. Changes to end fittings or cable length are faster. Kingmach’s support team can give you a firm date once they see your specs.